Product Description
Plain water gauge without drain or stop cocks, suitable for small boilers. Mounts 2-3/8″ nominally center-to-center. All brass, with 3/16 OD glass tube. Threaded 1/4-40, comes with boiler bushings. Drain valve can be installed on bottom.
Extra glass tubing may be purchased separately to make different length water gauges.
NOTE: To cut glass tube, make a small notch in the side of the glass tube using a small
triangle shape file. Hold glass tube with both hands and make a bending motion at the
notched point on the tube.
CAUTION: Wear leather gloves and eye protection while cutting glass.
Belting
Displacement Lubricator
Pressure Gauge with Syphon
Steam Engine #8
Steam Engine #3
Rick Weber (verified owner) –
I’ve also ordered about a dozen of these through the years and have had excellent results from their installation in my custom boilers. Good price and value.
Rick Weber (verified owner) –
Beautifully crafted gauge. As a builder, these are my favorite. Couldn’t even come close to machining these gauges to the precision offered at a relatively low price. I’ve probably ordered a dozen through the years, and all have worked very well.
Erin McDermott (verified owner) –
Gauge glass was two millimeters large than specified, so it didn’t fit. O rings were not supplied either.
pmrgang –
We apologize for the inconvenience. We have checked our stock and noticed that we have received over sized glass. We have shipped the correct pieces of glass out to you.
Thank you for bringing this to our attention. Have a great weekend. Jim PM Research Inc